How to Lay Drip Irrigation Pipes in Farm Irrigation

How to Lay Drip Irrigation Pipes in Farm Irrigation


When we are laying drip irrigation pipes, we need to pay attention to the following two items: firstly, it is be conducive to the growth of crops. Secondly, it is to give priority to safety.
 

 
The Laying of Drip Irrigation Pipe

1. Make sure to lay the drip irrigation pipes under the film. Do not lay upside down or screw down.
 
2. When drip irrigation belts were laid by machine, we need to carefully check the film laminating machine. Do not scrape the drip irrigation belt. The bearing should be put on the pulley and rolling organization. In order to ensure that the pulley is rolled sensitively, the drip irrigation belt  cannot be pulled out. If it is pulled out, the deformation of the drip irrigation belt will affect the dripping water quantity.

3. Irrigation should be carried out strictly according to the rotation irrigation group. Otherwise it may cause uneven water output or power waste due to insufficient pump operation. And the purpose of water saving, electricity saving, fertilizer saving and labor saving cannot be achieved.

4. After the system device is finished, water should be sent to the drip irrigation system in a timely manner to prevent the sun from blasting and accelerating the aging of pipes and drip irrigation belts.

5. During installation, operators should read the instructions of the use of each part carefully and connect each part by correct device methods.

6. Once the main, branch and attached pipes are installed in the field, irrigation pipes should be protected from being pressed and scraped on agricultural machinery and farm tools, which can prevent external damage to reduce the service life.

7. After the completion of drip irrigation equipment, special personnel should be organized to manage and prohibit others to dismantle,install and open and close valves without permission.

8. The plot of land with drip irrigation equipment should be complete, fine without any stubbles. Because stubble, stones, weeds and other things are easy to puncture the drip irrigation belt and hold up the plastic film to form water vapor in the plastic film, which can form lensing effect.
 

 
Drip Irrigation Belt Under Corn Film

9. When laying, the drip irrigation belt can be shallowly buried to prevent focus burns. Also we can put be a layer of 1 mm thick soil layer on the drip irrigation belt or plastic film in order to damage the lens composition, and then to prevent burns.

10. After the completion of drip irrigation, the main and branch irrigation pipes and connector should be recycled and saved for use next year.

11. After the accumulation of dirt in the filter, the loss of overflow is added. When the pressure difference between the two ends of the filter is 0.2-0.3MPa, it is necessary to clean it.

12. Regularly turn over the end of drip irrigation Pipeline and wash the dirt in the drip irrigation pipes.